FASST 2.4GHz Air Systems (7CH Mode/Multi Mode): 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14,

T14MZ, etc.

Futaba S.BUS servos, FrSky S Bus compatible servos D12MB

Model: TFR8SB (8CH FASST compatible receiver with RSSI & SB ports)

Dimension: 44.5*27.5*17mm

Weight: 11.5g

Operating Voltage Range: 3.5~10V

Servo Frame Rate: 14ms (FS – Normal Speed Mode)

7ms (HS – High Speed Mode)

1) Compatible with FASST 2.4GHz Air Systems (7CH Mode/Multi Mode)

2) SB port is compatible with Futaba S.BUS servos and FrSky S Bus compatible servos

3) With RSSI output

4) Two selectable failsafe setting options (use native failsafe on radio side or set failsafe on TFR8SB side)

5) S.BUS servos/S Bus compatible servos channel setting channel setting on TFR8SB

6) Improve sensitivity and stability

7) Wider and higher operating temperature range, suitable for all kinds of models

8) Firmware upgradeable

Turn on the transmitter, connect the battery to the receiver while pressing receiver’s F/S button. After the RED LED is

off and GREEN LED is solid, the binding process is completed and the receiver is operating normally.

TFR8SB support two selectable failsafe setting options, either use native failsafe position preset on the transmitter side,

or set failsafe on TFR8SB.

02/03/2012

If not disabling failsafe on the transmitter side, TFR8SB will use native failsafe position preset on the transmitter side.

TFR8SB supports failsafe function for all channels. Follow the steps below to set failsafe on TFR8SB:

1) Bind the receiver first, and disable failsafe on the transmitter side;

2) Set all transmitter controls to the desired failsafe position;

3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating the failsafe is

set up successfully.

I f you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.

Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and then release. The

red LED will flash fast in HS Mode and slow in FS Mode. Repeat this to alternate modes.

Channel setting for Futaba S.BUS servos and FrSky S Bus compatible servos can be performed at TFR8SB.

1, Connect the two pins of SB port and RSSI port by the provided cable.

2, Connect an S.BUS servo or S Bus compatible servo to the output connector (1~8) corresponding to the channel you want to set.

3, Connect battery to the receiver, RED blinking LED indicating the channel setting is completed in Mode A. To switch to Mode B,

press the button on receiver for three seconds until GREEN LED starts to blink, indicating the channel setting is completed in Mode B.

Mode A: RED LED blinks

Mode B: GREEN LED blinks

Futaba is trade name and/or trademark of their respective companies and are not products of FrSky Electronic Co., Ltd.

100555