Hornet OSD รุ่นใหม่ รูปทรงกระทัดรัดกว่าเดิม ตัวกล่องทำจากอลูมิเนียม แข็งแรงทนทาน สามารถทำงานแบบ Stanalone หรือร่วมกับ FY-21AP, FY-31AP, F3ZT เพื่อให้สามารถแสดงข้อมูลได้มากขึ้น เช่น แสดงเส้นขอบฟ้า(Artificial Horizon display)
ดาวน์โหลดคู่มือและ Firmwere upgrade ได้ ที่นี่
Brief Introduction
The Hornet- OSD overlays flight telemetry information onto your video image. The telemetry information displayed includes flight altitude, flight speed, flight direction, and home direction and so on. You also can save the telemetry information to a MICRO SD card, then realizing trace playback via FYGCS. The Hornet-OSD can be connected to the FY-21AP, FY-31APand FY-3ZT systems to display autopilot telemetric data, or to a GPS receiver to display positioning data.
Hornet-OSD automatically adapts to either PAL or NTSC video input and confirms if there is a MICRO SD card or not. The adaptive processes are within about 2 seconds.
Once the input video is detected even if there is interruption to the video signal, the telemetry data of the Hornet- OSD will continue to be transmitted via the video stream.
Application
Hornet-OSD can directly connect to the data output port of FY-21AP, FY-31AP or FY-3ZT, or separately connect to the output port of GPS module, and then overlay the flight data information to the video signal. The application figure is shown as bellow.
(Note：The modules in the imaginary line frame means that you can choose any one of these modules to connect )
Interface introduction
The telemetry data is as bellowing:
|
1 |
Attitude measurement error coefficient（refer to the prompt） |
11 |
The quantity of satellite used for positioning |
|
2 |
GPS speed (Unit: km/h) |
12 |
Power battery current (Unit: A) |
|
3 |
The pitch angle of the plane (Unit: deg) |
13 |
Relative altitude (Unit : m) |
|
4 |
The roll angle of the plane (Unit: deg) |
14 |
Horizon position display |
|
5 |
Current latitude and longitude of the plane (Format: dddmm.mmm ) |
15 |
The angle of turning to the return point (Unit: deg) |
|
6 |
Total flight time (Format: mm.ss) |
16 |
Course angle of flight (Unit: deg) |
|
7 |
Flight mode |
17 |
Operating temperature(Unit: ℃) |
|
8 |
Distance to take-off Point (Unit : m) |
18 |
The battery voltage of the video transmitter (Unit: V) |
|
9 |
Power battery voltage (Unit: V) |
19 |
The battery power consumed
(Unit: mA / h) |
|
10 |
Climb rate (Unit: m/s) |
|
|
Introduction for the flight State of FY-21AP / FY-31AP / FY-3ZT
|
Name |
Introduction |
|
RC |
Manual Flight. Autopilot deactivated. |
|
ABM |
Auto balance mode |
|
FAF |
For FY-21AP:Fixed Altitude flying mode; for FY-3ZT/FY-31AP:Air route fly mode |
|
RTL |
Auto Return Mode |
|
ACM |
Auto Circle Mode |
Display Modes Selection
The OSD can be controlled to show different display information via one spare channel of your radio Rx. There are 5 optional display modes controlled by the different PWM signals. You can use default mode if you do not want to change the display modes.
291154 | 
